Be careful when using PVC graining machine.

1. The PVC graining machine should be running forward; Avoid reversing.
2. The PVC graining production line shall not operate on an empty stomach, so it must be run with the heating machine, so as to avoid the phenomenon of sticky rod (holding axle).
3.The feeding port of the PVC graining machine is forbidden to enter the iron and other sundries in the hole. Lest cause accident, affect production.
Ii. Matters needing attention during the working process of granulator.
4. Pay attention to the changes of the body temperature at any time, and immediately heat up when you do not touch the blade with a clean hand. Until the note is in order.
2. When the bearing part of the reducer is burnt, or accompanied by noise, it should be repaired in time and refueling.
3. When the bearing parts of the main bearing room are ironed or noisy, please stop and check and add the butter. When working normally, the bearing room is added butter once every 5-6 days.
4. Pay attention to the operation rules of the machine; Such as: machine temperature, speed and speed, according to the situation, timely processing.
5. When the fuselage is running unstable, it should be noted that if the gap between the alignment of the shaft is too tight, it should be adjusted in time.